Waltron 3052 Disinfectants Analyzer

3052 Disinfectants Analyzer

Range: 0-5 ppm


Waltron’s 3052 Disinfectants Analyzer is the first choice for online analysis of monochloramine. The 3052 is trusted worldwide to deliver accurate and reliable readings with minimal maintenance and a low total cost of ownership. Typical applications are potable water, cooling water, industrial wastewater, and swimming pools.

  • Accurate and wide-range analysis

  • Multi-stream available

  • Fast-loop reservoir

  • Adjustable cycle and calibration frequency

  • Automatic calibration and validation (QA/QC)

  • Compact design

  • Color touchscreen display

  • Grab sample capability

  • Internal datalogger

  • Low reagent level alarm

  • No compression air required

  • Automatic start/stop based on sample flow detection

  • Minimal analyzer maintenance 

  • Process-photometer based on DPD-Method (DIN EN ISO7393-2; APHA/AWWA 4500-CI G)

Range

0-5 ppm


Accuracy

±  5% of the reading


Reproducibility

±  0.1 ppm or ±  2% of reading, whichever is greater


Analysis Time

10 min batch process


Sampling Frequency (Cycle Time)

One reading every 20 mins, adjustable


Required Maintenance

Monthly replenish reagents; Quarterly replace tubing


Reagent Consumption (approximate)

2 reagents, 2.5 L each month


Sensor Classification

Colorimetric with glass flow cell and LED source


Application

Steam cycle water, cooling water, process water


Ambient Temperature Range

10-45°C analyzer (50-113°F)


Atmospheric Temperature Range

No limits


Humidity

Up to 90% not condensable


Unit Dimensions

Height = 23.6″ (60 cm); Width = 15″ (38 cm); Depth = 8.3″ (21 cm)


Positioning and Installation Details

Wall mounting, bench supported, or panel mounting (optional)


Weight

17 kg (37.5 lbs)

Degree of Protection

IP55 (NEMA 4): Wet section, IP65 (NEMA 4x): Electronics

Alarms

2 or 4 configurable alarm relays (result, loss of sample, fault)


Power Supply

110-220 VAC, 50-60 Hz 80 VA


Certification (on request)

Meets low voltage and low electromagnetic compatibility directives


Temperature Range

5-55°C (41-131°F)


Inlet Sample

100-500 ml/min, atmospheric, flexible tubing O.D. 1/4″ (6mm)


Outlet Sample

Atmospheric, waste tubing O.D. 3/8″ (9mm)


pH

3-12


Sample Conditioning Requirements

Filtering between 10 and 60 micron, depending on the matrix, needed only to avoid clogging


Materials in Contact with Sample

Glass, Silicone, Plexiglass, Stainless Steel AISI 316

Analog Outputs

4-20 mA (galvanic isolator module available as option) or 0-5V

Serial I/O Options

RS232; RS485; MODBUS; PROFIBUS


Single/Multi-Point

Multi-point: zero and mid range


Matrix Corrections

Yes, sample blank correction


Manual/Automatic 

Both

Technical Documents