Waltron 2410 Oil in Water Analyzer

2410 Oil in Water Analyzer

Range: 0 – 99 ppm

The Waltron 2410 Oil-in-Water Monitor was developed specifically for the reliable ppm measurement of hydrocarbons in industrial clean water applications. The 2410 has many uses and its compact footprint , easy maintenance, and auto-clean function make it a good choice for hard-to-reach locations. The uncomplicated design utilizes optical sensors to measure absorbed and scattered light in a sample stream, and distinguishes between oil droplets and turbidity, calculating the oil concentration based on the sensor signal. The analyzer monitors continuously and activates alarms and relays as necessary. Applications include: boiler condensate returns, process cooling water, process steam monitoring, pump oil discharge, and wastewater.

  • Compact design
  • Calibrates directly to clean water
  • Wide range analysis: 1 – 99 ppm
  • Automatic and continuous self diagnostics
  • Turbidity compensation
  • Rapid Response
  • Minimal maintenance required
  • Automatic operation
PERFORMANCE

Range
0 – 99 ppm

Accuracy
∓ 2 ppm

Calibration
Calibrates directly to clean water

Current Outputs
0 – 20mA, 4-20mA (800Ω min. load); 0-5VDC, 1 – 5VDC (50KΩ min. load)

Alarms
Two adjustable operating delay alarms (0 – 60 sec, 10 – 240 sec); contacting rating 8A @ 240V

Power
230/115VAC or 24VAC, 50/60Hz; consumption 10VA max

CE Certification (on request)
Meets low voltage and low electromagnetic compatibility directives

Electrical Installation
EN61010-1EC664 category 11

OPERATING CONDITIONS

Sample Flow
0.26 – 0.53 gal/min (0.1 – 2.0 L/min)

Sample Temperature
34 – 104° F (1 – 40°C)

Ambient Temperature
34 – 140°F (1 – 60°C)

Pressure
1.45 – 145 psig (0.1 – 10 bar)

Humidity
90% RH Max @ 131°F (55°C)

MECHANICAL

Construction
Meets IP55

Dimensions
Height=8.5” (215mm); Width=9.5” (242mm); Depth=2.9” (73mm)

Weight
4.96 lbs (2.25 kg)

Finish
Corrosion resistant

Technical Documents